Installing the sliding block of cylinder bank 2

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

Remove the oil and dirt from the sliding block (3) .
Position the sliding block (3) and abut with the screw (1).
Position the special tool 2 249 166 on the intake camshaft (1) in the sliding block (2) area.
Preload the sliding block (3) with the special tool 2 249 166 (2) in direction of arrow .

Tighten down screw (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Sliding block on cylinder head
Screw M 7x35 10.9
	Tightening torque	20.5 Nm

Relieve the special tool 2 249 166 (1) and feed it out of the camshaft (2) and place aside.
Repeat the step for all the gates.

Courtesy of BMW OF NORTH AMERICA, INC.