Take engine out of installation orientation
- Lower engine by turning the spindle 2 361 506 (00 6 103) until the engine rests completely on the engine mounts.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Remove the engine bridge (1) with the help from another person.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Carefully guide out and remove special tools 0 496 437 (00 6 052) and 0 496 438 (00 6 053) .
- Remove the engine bridge.
- Loosen the screws (1) from the special tool 2 459 012 .
- Guide the special tool 2 459 012
out and remove.
- Tighten screw (1) of the engine mount, right, using standard tool, from above.
TIGHTENING TORQUE SPECIFICATIONS
| Engine mount to engine support bracket | ||
| M12 | tightening torque | 100 Nm |
- Prepare special tool 0 493 751 (11 9 150)
as shown.
- Tighten the screw of the left engine mount from the bottom with the special tool 0 493 751 (11 9 150) .
TIGHTENING TORQUE SPECIFICATIONS
| Engine mount to engine support bracket | ||
| M12 | tightening torque | 100 Nm |
- Install the reinforcement strut (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Engine mount reinforcement strut on front subframe | ||
| M12 | tightening torque | 110 Nm |
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Engine mount reinforcement strut on body | ||
| M12 | tightening torque | 110 Nm |
Follow-up work
- Refer to INSTALLING THE CLEAN AIR PIPE AND THE RESONATOR .
- Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
- Refer to INSTALLING THE TENSION STRUT ON THE RIGHT SHOCK TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM (DOOR SILL) .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .