Installing the coolant feed line for the right exhaust turbocharger

• Replace the banjo bolt of the coolant feed line.

  Parts:  Hollow bolt

• Replace seals (1).

  Parts:  Seals

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the coolant feed line for the left exhaust turbocharger.
• Position the coolant feed line.
• Position the banjo bolt (1) and screw in several threads.
• Apply the banjo bolt (1) hand-tight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Hand-tighten the bolt (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the banjo bolt (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the sealing rings (1) of the coolant lines (2).

  Parts:  Sealing rings

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect coolant lines (4).
• Connect coolant lines (3).
• Tighten down screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the lint-free rag (1).

Follow-up work 

• Refer to CONNECTING THE COOLANT HOSES TO THE HIGH-TEMPERATURE COOLANT RADIATOR .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING THE RIGHT AND LEFT UNFILTERED-AIR DUCT .
• Refer to INSTALLING HEAT SHIELD, TOP .
• Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
• Refer to INSTALLING THE LEFT LAMBDA OXYGEN SENSOR .
• Refer to INSTALLING THE RIGHT LAMBDA OXYGEN SENSOR .
• Refer to INSTALLING RIGHT CLEAN AIR PIPE .
• Refer to PARTIALLY INSTALLING THE RIGHT ENGINE VENTILATION LINE .
• Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING THE CARRIER PLATE .
• Refer to INSTALLING BOTH INTAKE FILTER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .