When replacing intake camshaft: Remount camshaft sensor wheel

• Rotate intake camshaft, if necessary in the position shown up to the recess (2).
• Loosen screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide out and remove the camshaft sensor wheel (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the camshaft sensor wheel (1) into the new intake camshaft.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Rotate intake camshaft, if necessary in the position shown.
  NOTE: The recess (2) must point up.
• Position camshaft sensor wheel and tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Camshaft sensor wheel to intake camshaft
M4 x35	Tightening torque	4.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.