Install brake caliper in the rear

Fit and tighten brake hose (2) on brake caliper.

TIGHTENING TORQUE SPECIFICATIONS

Brake hose to brake caliper, rear
	tightening torque	24 Nm

Hook the brake hose into the holder (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: RISK OF DAMAGE
Incorrect routing of the brake hose .
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail .

Do not install the brake hose in a twisted position.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert the brake hose (1) into the body side holder.
Make sure the retaining spring (2) fits correctly!
Attach and tighten the union screw (3).

TIGHTENING TORQUE SPECIFICATIONS

Brake pipe screw connection/Union screws
	tightening torque	17 Nm

Follow-up work

Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
Refer to INSTALL REAR BRAKE PADS .
Refer to PLACING BRAKE PADS ON BRAKE DISC/COMMISSIONING .
Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .
Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
Refer to FLUSH THE REAR BRAKE AND AIR BLEED (AFTER PART EXCHANGE) .
Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .