Installing the front wheel speed sensor
- Clean the bore for the wheel speed sensor with lubricating grease.
CONSUMABLE SPECIFICATIONS
| Consumable | ||
|---|---|---|
| Lubricating grease | 100 g, | 83 23 9 407 |
| Staburags NBU 12K | Tube | 810 |
- Install rear wheel speed sensor (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front wheel speed sensor on swivel bearing | ||
|---|---|---|
| Screw Replace screw. |
Tightening torque | 12 Nm |
- Connect the cable of the wheel RPM sensor in the holders (1).
- Connect plug connection and close housing cover (2).
Follow-up work
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .