Installing the rear tension strut
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the tension strut (3).
- Tighten the screws (1) and the nut (2).
TIGHTENING TORQUE SPECIFICATIONS
| Torsion strut on body and holder | ||
|---|---|---|
| M12x25 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |
| Nut M10 | Tightening torque | 38 Nm |
Follow-up work
- Refer to INSTALLING UNDERSHIELD (TANK COVER) .