Install the front top cross connection
- Attach the front top cross connection (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Top front cross connection to hood lock support | ||
|---|---|---|
| screw | Tightening torque | 19 Nm |
NOTE:
Perform the steps on the right and left side.
- Carefully feed in the holder (2) and tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder on headlight | ||
|---|---|---|
| screw | Tightening torque | 1.9 Nm |
- Tighten screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front reinforcement strut | ||
|---|---|---|
| screw | Tightening torque | 24 Nm |
- Mount the expanding rivets (1).
Follow-up work
- Refer to INSERT TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .