Preparing New Part
Further information is available.
NOTE:
TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see 4100... BMW/MINI BONDING INSTRUCTIONS (ALL X5 MODELS, 2019-2022) .
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see 4100... BMW/MINI BONDING INSTRUCTIONS (ALL X5 MODELS, 2019-2022) .
- Place the roof outer skin in position on the vehicle and adjust it to fit together with the roof trim strips.
- To maintain the short processing time starting from the adhesive task, prepare the following mounting material before the installation.
- (1) M6 To fix the roof outer skin in place, have screws, nuts and washers ready by the mounting hole.
Replace T-bolt
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Take the quantity and position from the component to be replaced.
- Replace T-bolts (1).
Parts: T-bolt
- Weld the T-bolt (1) onto the new part.