Preparing New Part

Further information is available.

NOTE: TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see 4100... BMW/MINI BONDING INSTRUCTIONS (ALL X5 MODELS, 2019-2022) .

Adjust the luggage compartment floor in combination with side panel and tail panel to fit and secure.
Prepare the joints in areas (1) and (2) using the bond-and-rivet method.

In areas (1) and (2) drill out 9 bores to dia. 4.2 mm for blind rivets.

Area	Number
1	6
2	3

Courtesy of BMW OF NORTH AMERICA, INC.

Prepare area (1) for joining by glue rivet method.
In area (1) drill out 4 bores dia. 4.2 mm for blind rivets.

Courtesy of BMW OF NORTH AMERICA, INC.
In area (1) drill out 3 bores dia. 4.2 mm for blind rivets.
Prepare area (2) for joining by welding.
Remove new component. Deburr bores.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the coarse thread bolts and threaded weld bolts, surface steel

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
Take the number and position from the component to be replaced or the installed parts.
Replace the coarse thread bolt (1) and the threaded weld bolt (2).
Parts: Coarse thread bolt (1), threaded weld bolt (2)
Weld the coarse thread bolt (1) and threaded weld bolt (2) onto the new part.

Courtesy of BMW OF NORTH AMERICA, INC.