Remove the drive for the roller sunblind
Preliminary work
- Refer to REMOVING LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING THE LEFT AND RIGHT BOTTOM C-PILLAR TRIM PANEL .
- Refer to REMOVING THE REAR DOOR SILL COVER STRIP (ON ELECTRICAL REAR SEAT) .
- Refer to REMOVING LEFT AND RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to REMOVING THE LEFT AND RIGHT D-PILLAR TRIM PANEL .
- Refer to REMOVING THE TOP LEFT AND RIGHT B-PILLAR TRIM PANELS PARTIALLY .
- Refer to REMOVING A-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to REMOVING LEFT AND RIGHT SUN VISORS .
- Refer to REMOVING THE COUNTER SUPPORT FOR THE SUN VISOR ON THE LEFT AND RIGHT .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to REMOVING ALL GRAB HANDLES .
- Refer to LOWERING THE HEADLINING (WITH PANORAMA ROOF) .
- Loosen screw (1).
- Disassemble expanding rivet (2).
- Remove cover panel (3).
- Mark the drive for the roller sunblind (3) before removal.
The drive for the roller sunblind (3) must not be mixed up with the drive for the glass slide/tilt roof panel .
- Unlock plug connection (2) and disconnect.
- Loosen screws (1).
- Remove the drive for the roller sunblind (3).