Install the drive for the roller sunblind

• Position the drive for the roller sunblind (3) that was marked before the removal.

  The drive for the roller sunblind (3) must not be mixed up with the drive for the glass slide/tilt roof panel  .

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Drive on body
  Screw	tightening torque	5 Nm

• Connect and lock the plug connection (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cover (3).
• Install the expanding rivet (2).
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Drive on body
  Screw	tightening torque	5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE HEADLINING (WITH PANORAMA ROOF) (LOWERED) .
• Refer to INSTALLING ALL GRAB HANDLES .
• Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
• Refer to INSTALLING COUNTER SUPPORTS FOR THE LEFT AND RIGHT SUN VISOR .
• Refer to INSTALLING THE LEFT AND RIGHT SUN VISOR .
• Refer to INSTALLING LEFT AND RIGHT A-PILLAR TRIM PANEL .
• Refer to PARTIALLY INSTALLING THE B-PILLAR TRIM PANELS AT THE TOP LEFT AND RIGHT .
• Refer to INSTALLING D-PILLAR TRIM PANEL ON LEFT AND RIGHT .
• Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
• Refer to INSTALLING LEFT AND RIGHT C-PILLAR TRIM PANELS AT THE BOTTOM .
• Refer to INSTALLING LEFT AND RIGHT C-PILLAR TRIM PANELS AT THE BOTTOM (3RD ROW OF SEATS) .
• Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
• Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .