Removing the wiring harness section of the blow-off valve for cylinders 5-8
Prerequisite
- Ignition is switched off.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING BOTH INTAKE FILTER HOUSINGS .
- Refer to REMOVING CARRIER PLATE .
- Refer to RELEASING LEFT CHARGE AIR LINE PARTIALLY .
- Refer to PARTIALLY REMOVING THE LEFT ENGINE VENTILATION LINE .
- Refer to REMOVING LEFT CLEAN AIR PIPE .
- Refer to PARTIALLY RELEASING THE RIGHT CHARGE AIR LINE .
- Refer to PARTIALLY REMOVING THE RIGHT ENGINE VENTILATION LINE .
- Refer to REMOVING RIGHT CLEAN AIR PIPE .
- Refer to REMOVING THE RIGHT TENSION STRUT ON THE SHOCK TOWER .
- Refer to REMOVING COVER FOR THE RIGHT DME CONTROL UNIT .
- Refer to REMOVING THE RIGHT UNFILTERED-AIR DUCT .
- Release the wiring harness section of the blow-off valve in area (2).
- Unlock plug connection (1) and disconnect.
- Unlock plug connection (1) and disconnect.
- Guide the wiring harness section out.