Installing transmission cross member

• Install the transmission cross member (3).
• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Transmission cross member to rubber mounts
  M12	tightening torque  68 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Transmission cross member to body
  M8	tightening torque  19 Nm

• Remove the transmission jack.

Follow-up work 

• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .