Installing wheel electronics

NOTE: TECHNICAL INFORMATION
It is absolutely necessary to replace the tire valve to prevent leaks.
Before installing the tire valve: Clean the bore in the wheel rim thoroughly and deburr where required.

Insert valve insert (1) in arrow direction in wheel electronics.

Courtesy of BMW OF NORTH AMERICA, INC.
Fit sealing ring (1) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Ensure correct installation position.
The mark (1) on the sealing ring must point up.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the valve insert with the wheel electronics (1) into the cleaned bore in the rim.
The wheel electronics must rest against the wheel rim.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the union nut (1).
Parts: Coupling nut
Screw on the union nut (1) manually until it abuts.
Press the wheel electronics evenly into the rim base.

Tighten union nut (1).

TIGHTENING TORQUE SPECIFICATIONS

Tire valve to wheel rim
Replace union nut. Tighten screw connection in one go. Do not retighten the screw connection.	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure the wheel electronics rest evenly against the wheel rim after tightening.