Installing fog light support
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Correctly position the fog light bracket (3) and engage at detents (arrows).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front fog lamp holder to bumper panel | ||
| screw | Tightening torque | 3 Nm |
- Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .
- Position holder (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front fog lamp holder to bumper panel | ||
| screw | Tightening torque | 3 Nm |