Securing the wiring harness of the active stabilizer in the rear

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Securing the wiring harness of the active stabilizer

Position wiring harness.
Secure the vehicle wiring harness on holders (4) and (3).
Connect, lock and fasten connectors (1) and (2) on the bracket.

Courtesy of BMW OF NORTH AMERICA, INC.
Position wheel arch panel.
Tighten nuts (2).
Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Wheel arch cover
Thermoplastic hexagon screw	Tightening torque	2.6 Nm
Plastic nut	Tightening torque	2.6 Nm