Install the cover of the camber control arm on the left and right

NOTE: Perform the steps on the right and left side.

Install the cover of the camber control arm

Insert the cover of the camber control arm (2) on the camber control arm (3) and place it into position.
NOTE: Note the direction of installation (A). The arrow shows the direction of travel.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Cover to camber control arm
Thermoplastic ovalhead screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.