When replacing intake camshaft: Remount camshaft sensor wheel
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate intake camshaft, if necessary in the position shown up to the recess (2) .
- Loosen screw (1)
.
- Guide out and remove the camshaft sensor wheel (1)
.
- Guide the camshaft sensor wheel (1)
into the new intake camshaft.
- Rotate intake camshaft, if necessary in the position shown.
NOTE:
The recess (2) must point up.
- Position camshaft sensor wheel and tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Camshaft sensor wheel to intake camshaft | ||
|---|---|---|
| M4 x35 | Tightening torque | 4.5 Nm |
- Rotate intake camshaft, if necessary in the position shown up to the recess (2) .
- Loosen screw (1)
.
- Guide out and remove the camshaft sensor wheel (1)
.
- Guide the camshaft sensor wheel (1)
into the new intake camshaft.
- Rotate intake camshaft, if necessary in the position shown.
NOTE:
The recess (2) must point up.
- Position camshaft sensor wheel and tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Camshaft sensor wheel to intake camshaft | ||
|---|---|---|
| M4 x35 | 4.5 Nm | |