Installing the high-pressure line between the high-pressure pump and the high-pressure fuel rail
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Guide in the high pressure line (4) in the mount (3) and install.
- Tighten the union nuts (arrows) with the special tool 0 495 280 (13 0 140)
.TIGHTENING TORQUE SPECIFICATIONS
High pressure line between the rail and the high pressure pump M14x1.5 tightening torque 33 Nm - Feed in and install wiring harness section of the engine wiring harness (4)
.
The locks (3) must engage audibly.
- Connect connectors (1) and (2) and lock.
The connectors (1) and (2) must audibly engage.
Follow-up work
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to MOUNTING THE SERVICE OPENING IN THE SOUND INSULATION ON TOPPING OF THE ENGINE .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to RESET ULTRA-SMALL QUANTITY ADAPTATION .