Install the rear section of the front wheel arch cover
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Feed in the rear section of the wheel arch cover (1).
- Tighten screws (arrows).TIGHTENING TORQUE SPECIFICATIONS
Wheel arch cover Thermoplastic hexagon screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm
Follow-up work
- Refer to MOUNTING THE WHEEL .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM (DOOR SILL) .