Installing intake filter housing
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
Precondition
Ignition is switched off.
- Check rubber mount (1)
for correct fit in the intake filter housing.
- Feed in the cable of the Lambda oxygen sensors through the opening (arrow) on the intake filter housing (1).
- Connect intake filter housing (1) with the clean air pipes (2) .
- Install intake filter housing (1)
and fasten in the rubber mounts (markings).
- Tighten clamps (1)
.TIGHTENING TORQUES SPECIFICATION
Clean air pipe to upper section of intake filter housing cl. Tightening torque 3 Nm - Attach the cable (4) of the Lambda oxygen sensor to the clamps.
- Attach the connector (2)
to the holder (3)
and lock.
The connectors (2) must engage audibly.
- Connect the connector (1)
of the Lambda oxygen sensors and lock.
The connectors (1) must engage audibly.