Install bracket for right intake silencer
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Position holder (3).
- Tighten the screws (1).
Tightening Torques
| Screw on the holder of the intake silencer | ||
| M6x16 screw | Tightening torque | 8 Nm |
- Tighten nut (2).
Tightening Torques
| Nut on the holder of intake silencer | ||
| Nut M6 | tightening torque | 8 Nm |
- Version with a gasoline particulate filter:
Position holder (2) of the gasoline particle sensor.
Tighten the screws (1).
Tightening Torques
| Screw on the holder of the intake silencer | ||
| M6x16 screw | tightening torque | 8 Nm |