Removing the exhaust turbocharger (cylinder head removed)

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Spring preload .
Injury hazard!

The use of the specified special tool (tool) is mandatory.
Carry out the described steps properly.

NOTE: RISK OF DAMAGE
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .

Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.

CAUTION: Heavy component .
Heavy components can lead to injury or damage .

Remove and install heavy components with the aid of another person/other persons.

NOTE: RISK OF DAMAGE
Damage of the electric wastegate valve controller .
Excessive force when removing and installing a jammed exhaust turbocharger may damage the electric wastegate valve controller .

Do not pull on the electrical wastegate valve controller or on the coupling rod.
Apply force only at the turbine housing and exhaust manifold.
Do not pull on the compressor housing.

Loosen screws (1) .
Feed out and remove the heat shield (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen nuts (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Guide out and remove the exhaust turbocharger (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Guide out and remove the seals (1) on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.