Install the acoustic cover for the oil sump
- Feed in and install the acoustic cover (2) of the oil pan.
- Secure expanding rivet (1).
- Check the Christmas tree clip (1) for damage, replace if necessary.
Parts: Christmas Tree clip
- Attach the Christmas tree clip (1).
- Secure expanding rivets (1) and (2).
- Secure expanding rivet (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Position the transmission oil lines (1) on the bracket (2).
Make sure the marks (3) are positioned correctly on the holder (2).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Insert and install the holder (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder for transmission oil line | ||
| Screw | Tightening torque | 4 Nm |
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
- Secure clamps (2).
- Insert and install the positive battery cable (4).
- Secure positive battery cable (4) at the clamp (5).
- Tighten the nut (3) hand-tight.
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Correctly attach the positive battery cable (1) to the anti-twist lock (2).
- Tighten the nut (3).
TIGHTENING TORQUE SPECIFICATIONS
| Battery positive lead to starter | ||
| M8 | Tightening torque | 13.5 Nm |
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .