Installing vehicle electrical system support battery
- Install the battery (4).
- Connect the vent hose (1).
- Position the battery carrier and tighten it with the bolt (3).TIGHTENING TORQUE SPECIFICATIONS
Battery carrier to body in engine compartment Screw tightening torque 15 Nm - Join positive battery terminal at positive battery pole.
- Tighten the nut on the positive battery terminal (2).
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery terminal to battery | ||
| Nut | tightening torque | 5 Nm |
Follow-up work
- Refer to CHECKING THE VENT HOLES OF THE BATTERY .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .