Installing the front brake disc chamber (high brake)
NOTE:
TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle). Fit new brake discs only together with new brake pads.
Brake discs must only be replaced in pairs (per axle). Fit new brake discs only together with new brake pads.
- If an arrow 1 is engraved on the brake disk, it must point in the driving direction!
In this case, the left and right brake discs are different!
- Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
- Mount brake disc (2).
- Position and tighten the screw (1).
- Replace the screw (1).
Parts : Screw
TIGHTENING TORQUE SPECIFICATIONS
| Brake disc to front wheel hub | ||
|---|---|---|
| M8 Replace screw. |
tightening torque | 16 Nm |
- Install the brake caliper in the direction of the arrow.
- Insert screws (1) and tighten them.
- Replace screws (1).
Parts : screw
TIGHTENING TORQUE SPECIFICATIONS
| Brake caliper/brake anchor plate at front swivel bearing | ||
|---|---|---|
| M12 Replace screw. |
tightening torque | 110 Nm |
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING FRONT BRAKE PADS .
- Refer to PLACING BRAKE PADS ON BRAKE DISC/COMMISSIONING .
- Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .