Installing rear brake hose
- Attach brake hose to the holder (1).
- Fit and tighten brake hose (2) on brake caliper.
Never twist brake hose and avoid all contact with components attached rigidly to the body.
TIGHTENING TORQUE SPECIFICATIONS
| Brake hose to brake caliper, rear | ||
|---|---|---|
| tightening torque | 24 Nm | |
- Attach and tighten union screw (1).
Hold on to square shaft, if necessary (2).
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
|---|---|---|
| tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH THE REAR BRAKE AND AIR BLEED (AFTER PART EXCHANGE) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .