Preparing New Part
- Adjust the new part (1) and prepare it the areas (2) for joining by welding.
- Prepare the new part in areas (1) and (2) for joining by welding.
- In the area (2), pay attention to the spot-welded adhesive joints of the panel above with the floor panel.
- Adjust the new part (1) and prepare it in the area (2) for joining by welding.
- Prepare the new part in area (1) for joining by welding.
- Adjust the connecting plate and prepare for joining by welding in the areas (1) and (2).
- In area (2), observe the spot-welded adhesive joints of the panels located behind it.
- Prepare the area (2) so that the repair spot-welds can be set on the production spot-welds.
- Prepare the new parts in the areas (1) for joining by welding.
- Prepare the new part in area (1) for joining by welding.
- Make separating cut (1) on new part in accordance with separating cut on vehicle.
- Adjust new part (1) and prepare for joining by welding in areas (2).
- Prepare new part (2) for joining by welding in the area of the separating cut (1).
Replacing the coarse thread bolts and threaded weld bolts, surface steel
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Take the number and position from the component to be replaced or the installed parts.
- Replace the coarse thread bolt (1) and the threaded weld bolt (2).
Parts: Coarse thread bolt (1), threaded weld bolt (2)
- Weld the coarse thread bolt (1) and threaded weld bolt (2) onto the new part.
Check ground pins and replace if necessary
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Check the ground pins (1) for stability and replace if necessary.