Installing LED fan

• Positioning LED fan (3).
• Tighten down screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  LED fan on lid
  Screw	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the connector (1).
• Check seal (4) for damage, replace if necessary.
• Connect the connector (1) to the LED fan (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cover cap (2).
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
• Refer to MOUNTING THE WHEEL .