Installing the guide for the rear bumper panel at the side
- Correctly position the guide for the rear bumper panel at the side (3).
- Tighten nuts (2).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper guide, rear | ||
|---|---|---|
| Nut | Tightening torque | 6 Nm |
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
Follow-up work
- Refer to INSTALL REAR BUMPER PANEL .
- Refer to INSTALLING REAR REFLECTOR .
- Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALL THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .