Installing rear spring strut

NOTE: RISK OF DAMAGE
Failure to comply with the specification .
Component damage .

NOTE: TECHNICAL INFORMATION
Secure component against falling.

Courtesy of BMW OF NORTH AMERICA, INC.

Guide in spring strut (1) from below. Align the solenoid valve with the control link while doing so.
Position the spring strut in the wheel arch.
Replace screws (1).
Parts: Screws

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Rear spring strut/air suspension on body
M10 Replace screw.	Joining torque Angle of rotation	56 Nm 90°

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Courtesy of BMW OF NORTH AMERICA, INC.