Installing the electric coolant pump for the charge air cooler and the air conditioning condenser
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Position electric coolant pump (3) .
- Connect and lock the connector (2) .
- Make sure the connector (2) engages audibly.
- Connect and lock coolant line (1) .
- Make sure that the coolant line (1)
engages audibly.
- Insert and install the retainer (1) .
- Make sure the retainer (1) is correctly positioned on the bracket (2) .
- Tighten nut (3)
.TIGHTENING TORQUES SPECIFICATION
Electric coolant pump to holder M6 tightening torque 8 Nm - Connect and lock coolant line (1) .
- Make sure that the coolant line (1) engages audibly.
Follow-up work
- Refer to INSTALLING HEAT MANAGEMENT MODULE .
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to INSTALLING THE LOW-TEMPERATURE COOLANT EXPANSION TANK .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .