Remove the mounted parts from the front axle support
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
Removing the right engine mount
- Unscrew the bolts (1) on the engine mount.
- Remove engine mount (2)
.
Removing the anti-roll bar
NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.Version A Removing the anti-roll bar
- Loosen screws (1) .
- Release the anti-roll bar (2)
with the upper section (3)
and the lower part (4)
of the retainer from the front subframe and remove it.
Version B: Remove the active stabilizer
- Loosen screws (1) .
- Release the active anti-roll bar with the upper section (2)
and the lower part (3)
of the retainer from the front subframe.
- Loosen screws (1) .
- Loosen the holder (2) .
- Release the active anti-roll bar with the upper section (3)
and the lower part (4)
of the retainer from the front subframe and remove it.
Removing the electromechanical steering gear
- Loosen screws (1) .
- Remove the electromechanical steering gear (2)
.