Installing the center cowl upper part
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Installing the center cowl upper part (3).
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Cowl upper part center to bottom cowl Screw tightening torque 2.6 Nm - Use the holders to fasten the wire (1) to the center cowl upper part (3).
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Cowl upper part center to bottom cowl Screw tightening torque 2.6 Nm
Follow-up work
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .