Securing the wiring harness section of the cylinder head cover on the right
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Connect connectors (3) and lock.
The connector (3) must engage audibly.
- Tighten the nut 2.Tightening torques
Positive battery cable to alternator M8 tightening torque 19 Nm - Mount cover (1) on nut (2).
- Position oil filler neck (2).
- Tighten down screw (1).
Tightening torques
| Oil filler neck | ||
| M6x16 | tightening torque | 10 Nm |
- Fix clip (2).
- Tighten down screw (4).
Tightening torques
| Hexagon screw M6 with threaded bolt M5 | ||
| Screw M6 with threaded bolt M5 | tightening torque | 10 Nm |
- Position the grounding point (5).
- Tighten nut (3).
Tightening torques
| Ground cable on cylinder head cover / ground pin | ||
| Nut M5 | tightening torque | 4.6 Nm |
- Tighten down screw (1).
Tightening torques
| Wiring harness to cylinder head cover | ||
| M6x16 screw | tightening torque | 10 Nm |
- Position the wiring harness (3).
- Fix wiring harness mountings (2).
- Tighten down screw (1).
Tightening torques
| Wiring harness to cylinder head cover | ||
| M6x16 screw | tightening torque | 10 Nm |
- Secure the wiring harness mounting 1.
- Fix wiring harness mountings 2.
- Secure the wiring harness mounting (5).
- Secure the wiring harness of the integrated power supply module (4) to fixtures (3).
- Tighten the screws (2).
Tightening torques
| Wiring harness to cylinder head cover | ||
| M6x16 screw | tightening torque | 10 Nm |
- Clip in transmission wiring harness (1).
- Connect and lock the connector on pressure sensor (1).
- Connect and lock connector (2) on the intake camshaft sensor of cylinder bank (1).
- Connect and lock connector (1) on the exhaust camshaft sensor of cylinder bank (1).
- Connect and lock connector (1) to (3).