Remove left and right output shaft
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
Remove left output shaft
- Position the aluminum drift (1) on the output shaft (2) .
- Knock out the output shaft (2)
from the front axle transmission with an aluminum mandrel (1)
.
- Release swivel bearing (1) out of special tool 2 413 317
on the upper wishbone.
Do not allow swivel bearing (1) to hang down from the brake hose.
- Guide out the output shaft (1)
in the arrow direction and remove.
Secure the swivel bearing
- Fasten the swivel bearing (1)
by using the special tool 2 413 317
to protect it from tilting outwards.
Swivel bearing (1) must not hang down from the brake hose.
Remove right output shaft
- Position the aluminum drift (2) on the output shaft (1).
- Knock out the output shaft (1)
from the front axle transmission with an aluminum mandrel (2)
.
- Release the swivel bearing (1)
from the special tool 2 413 317
on the upper wishbone.
- Pull the spring strut (1) slightly forwards in the driving direction.
- Guide out the output shaft (2)
in the arrow direction and remove.
Secure the swivel bearing
- Fasten the swivel bearing (1)
by using the special tool 2 413 317
to protect it from tilting outwards.
Swivel bearing (1) must not hang down from the brake hose.