Fastening the right and left output shafts onto the wheel bearing
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
Fasten the output shaft on the wheel bearing
NOTE:
TECHNICAL INFORMATION
The installation note for front gearing must be observed at all times.
The installation note for front gearing must be observed at all times.
- Replace the collar screw (1)
and compression spring (2)
.
Parts: Collar screw and compression spring
- Note installation position of compression spring (2) .
- Keep the collar screw (1)
and the front gearings of the wheel bearing and the output shaft clean and free of grease.
- Hand-tighten the collar screw (1)
with the compression spring.NOTE: TECHNICAL INFORMATION
The front gearing of the wheel bearing and output shaft must be installed in an interlocking position (tooth-in-tooth). - Ensure positive locking by mutual twisting of the wheel bearing (1) and the output shaft (2) .
- Press brake pedal.
- Tighten the collar screw.TIGHTENING TORQUES SPECIFICATION
Output shaft to wheel bearing M16 Replace collar screw and spring. Joining torque 210 Nm Angle of rotation 90°