Removing the intake camshaft (cylinder head removed)
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
- Pay attention to the numbering on the intake camshaft bearing cap.
The intake camshaft bearing caps are numbered from (E1) to (E6) and are stored according to their numbering in the special tool 0 495 105 (11 4 480) .
The intake camshaft bearing cap (E) is a thrust bearing.
- Release screws in the right sequence (14) till (1) in semi circle pattern.
- Set all intake camshaft bearing caps neatly in the special tool 0 495 105 (11 4 480) .
- Pull out and remove intake camshaft (1) from above.