Install the sealing cap with radial shaft seal

Clean sealing surfaces.
Apply the sealing compound at the contact points (arrows) on the crankcase and oil pan.
SEALING COMPOUND SPECIFICATIONS

Sealant Drei Bond 1209 30 ml, Tube 07 58 9 062 376
Check the fitting sleeves for damage and replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The work must be performed with vehicle care to prevent component damage.
Push the sealing cap (2) with the shaft seal and support ring (1) and abut (arrow).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The work must be performed with vehicle care to prevent component damage.
Counter-hold the sealing cap (2) with the shaft seal in the lower area (arrow).
Install the support ring (1) on the camshaft.
Slide the sealing cap (2) with the upper shaft seal above the support ring (1) and abut.

Courtesy of BMW OF NORTH AMERICA, INC.
Press on the casing (1) and remove the support ring (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Hand-tighten the bolts (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws (1).
Parts: Screws
Hand-tighten the bolts (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Sealing cap with shaft seal to crankcase
Torx screw M6	tightening torque 10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Upper oil sump section to sealing cap
M8 Replace screws.	tightening torque 27 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work