Remove the convenience charging electronics (KLE)
WARNING:
High-voltage system
.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially traine and technically experienced personnel.
- For additional information see:
- For additional information see:
Preliminary work
- Refer to REMOVING FLAP IN LUGGAGE COMPARTMENT TRIM PANEL ON RIGHT .
- Refer to DE-ENERGIZING THE HIGH-VOLTAGE SYSTEM .
- Refer to CHECKING THAT NO VOLTAGE IS APPLIED .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE RIGHT TENSION STRUT ON THE SHOCK TOWER .
- Refer to REMOVING THE INTAKE FILTER HOUSING (TENSION STRUT ON SHOCK TOWER REMOVED) .
- Refer to REMOVING CLEAN AIR PIPE AND RESONATOR .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLING SYSTEM .
WARNING:
High-voltage system
.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see:
- For additional information see:
- Unlock the connector from the signal line (1) and disconnect.
- Unclip the signal line (1).NOTE: TECHNICAL INFORMATION
Observe the additional information for unlocking and disconnecting various plug connections in electrical and hybrid vehicles! - Unlock and disconnect the high-voltage connector (1).
- Unlock and disconnect the high-voltage connector (2).
- Unlock and disconnect the high-voltage connector (3).
- Unlock and disconnect the high-voltage connector (4).
- Carefully raise the clamps (1) from the coolant connections.
» Do not pull the coolant connections off at this time!
- Connect the special tools 2 336 647 to all high-voltage connections.
- Prepare the collecting vessel for the coolant.
- Disconnect the coolant line (1).
- Disconnect the coolant line (2).
- Unfasten nut (1).
- Remove the convenience charging electronics (KLE) (2).