Checking the gel pad
Check
- Check the silicone-coated surface (1) and the PCB (2) for damage.
Result
» The silicone-coated surface (1) is damaged.
Measure
- Replace the gel pad.
Result
» PCB (2) is damaged.
Measure
- Replace rain-light-solar-condensation sensor.
Replacing the gel pad
NOTE:
RISK OF DAMAGE
Damage to the surface .
The use of sharp-edged tools can damage the surface .
Damage to the surface .
The use of sharp-edged tools can damage the surface .
- Only use microfiber cloths.
- Pull off the gel pad (1) manually.
Do not touch or damage the PCB (2).
- Remove present residual gel using a microfiber cloth.
- Clean the surface of the rain-light-solar-condensation sensor with a microfiber cloth soaked in a solvent cleaner R2.CONSUMABLE SPECIFICATIONS
Cleaning agent R2 500 ml 83190417324 - Pull off the yellow protective film (1).
- Apply the gel pad (1) centered on the surface of the rain-light-solar-condensation sensor (2).
Do not squeeze out any air pockets present.
Air pockets disappear within 30 minutes after mounting the sensor to the windscreen.
- Pull off the protective film (1).