Emptying expansion tank
NOTE:
TECHNICAL INFORMATION
Before work is first performed on the DSCi brake (integrated brake), the web-based training "DSCi" should first be successfully completed. To do this, the web-based training "DSCi" must be started in your Learning Management System (TMSi).
Before work is first performed on the DSCi brake (integrated brake), the web-based training "DSCi" should first be successfully completed. To do this, the web-based training "DSCi" must be started in your Learning Management System (TMSi).
NOTE:
TECHNICAL INFORMATION
Use only BMW-approved brake fluids.
Use only BMW-approved brake fluids.
Preliminary work
- Refer to PERFORMING THE BRAKE FLUID CHANGE SERVICE FUNCTION WITH THE DIAGNOSTIC SYSTEM .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to DISTINGUISHING THE CALIPERS FROM DIFFERENT MANUFACTURERS .
- Open sealing cap (1).
- Start the brake fluid change service function.
- Work through the instructions in the service function in sequence .
- Connect the vent hose with the collecting vessel to the bleed valve (1) on rear right brake caliper.
- Open bleed valve (1).
- Brake fluid leaks out until the lowest level of the brake fluid level sensor in the expansion tank has been reached.
- Close bleed valve.
TIGHTENING TORQUE SPECIFICATIONS
| Rear bleed valve | ||
|---|---|---|
| Bleed valve | tightening torque | 10 Nm |