Installing the actuator on the hood hinge
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Insert the actuator (3) into the rear guide pin and push it toward the rear up to the stop.
- Replace the screw (2).
Parts: screw
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Actuator to engine compartment lid hinge | ||
|---|---|---|
| M6x10 Replace screw. |
tightening torque | 8 Nm |
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .