Installing the protective plate on the brake fluid expansion tank
- Install the protective plate (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Protective plate to holder | ||
|---|---|---|
| Nut M8 | tightening torque | 10 Nm |
| Flat-head screw M8x22 | tightening torque | 35 Nm |
Follow-up work
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .