Install the Soft-close motor

NOTE: Description is for left component only. Procedure on the right side is identical.

Install the soft-close motor, together with the Bowden cable (1), in the vehicle.
Attach the cable linkage (2) to the trunk lid lock.
Clip counter support (1) into trunk lid lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Clip the soft-close automatic (2) into the holders (3).
Connect plug (1).

G14367615

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE BATTERY COVER .
Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
Refer to INSTALLING THE REAR DOOR SILL COVER STRIP .
Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
Refer to INSTALLING THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .