Installing the base plate and holder for the pennant holder

• Tighten the screws (1) for the holder for pennant holder (2) hand-tight.
• Hand-tighten the screws (3).
• Mount the expanding rivets (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position base plate for pennant holder (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1).

TIGHTENING TORQUE SPECIFICATIONS

Base plate to base plate holder
Nut M6	Tightening torque	12 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Base plate holder to carrier support
M6 screw Use the screw lock Loctite 243  .	Tightening torque	12 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Base plate holder
M6 screw Use the screw lock Loctite 243  .	Tightening torque	12 Nm