Install headlight

Checking blocking of the horizontal setting 

• Insert and position the headlights (2).
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front light combination, top
  Screw	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front light combination, bottom
  Screw	tightening torque	8 Nm

• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position trim panel (3).
• Install the expanding rivet (2).
• Install the seal (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the adhesive tape in area (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to ADJUSTING HEADLIGHTS .