Installing the holder for the Digital Motor Electronics control unit on the right

• Insert and position the bracket (1) for the DME control unit.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure clamps (3).
• Install the bracket (2) for the DME control unit.
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and lock the wiring harness section (2) in arrow direction.

  The lock (1) must audibly engage.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the integrated power supply module (PDM) (4).

  The lock (3) must audibly engage.

• Feed in and install DME control unit (2).

  The locks (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (2) and lock.

  The connectors (2) must engage audibly.

• Connect connectors (1) and lock.

  The connectors (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the connector (2) to the holder (3) and lock.

  The connectors (2) must engage audibly.

• Connect connectors (1) and lock.

  The connectors (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the cover (1) in direction of arrow on the bracket (2) and install it.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Ensure that the locking mechanisms (1) engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING COVER FOR THE RIGHT DME CONTROL UNIT .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT and INSTALL THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .