Secure the wishbone on the top left and right on the swivel bearing
NOTE:
Perform the steps on the right and left side.
Fastening the wishbone to the top of the swivel bearing
- Position the pin of the top control arm (3) in the bore of the swivel bearing (4).
- Replace the screw (2) and the nut (1).
Parts: Bolt and nut
- Insert screw (2).
- Tighten nut (1).TIGHTENING TORQUES SPECIFICATION
Upper wishbone to swivel bearing M10 Replace screw and nut. Tightening torque 56 Nm - Remove the special tool for attaching the swivel bearing.